Ardrox®
2302 is a mixture of solvents, activators and corrosion inhibitors. It consists of two layers:
an upper layer oil seal to prevent evaporation of the active paint removing solvents in the lower
layer.
Ardrox®
2302 contains no phenolic compounds, aromatic solvents or heavy metals.
Ardrox®
2302 will remove a wide range of paint schemes including baked acrylics, epoxies,
polyurethanes, and phenolics. It will also remove carbon or carbonaceous deposits, polymerized
gum and lacquer deposits.
Application :
Ardrox®
2302 is used as supplied. The total content of the container must be emptied into the
tank.
The recommended operating temperature range is 80 - 110°C (176 - 230°F). The product may be
used for short periods at higher temperatures up to a maximum of 140°C (284°F) for removal of
more obdurate finishes. In all cases, ensure, that the seal is properly maintained and all local
regulations complied with, considering the 108°C (228°F) flash point of the lower layer.
a) Immersion - Immerse dry components to be stripped in Ardrox® 2302 in the lower layer until
paint or carbon deposits have become fully softened or detached.
b) Drain - drain components (over Ardrox® 2302 tank) for approximately one minute.
c) Immersion - Immerse components in an Ardrox® primary cleaner at 10% by volume at room
to reduce vapors and aid subsequent pressure rinsing.
d) Pressure rinse - Pressure rinse components. The use of an Air/Water Gun or high pressure
water rig is recommended.
e) Dry - Dry components thoroughly using compressed air (or an air recirculation oven at 40-
80°C / 140 - 176°F).
